View Cart
speargun epoxy

Herranen Speargun Epoxy

Specially Formulated for laminating speargun woods and finish coatings on spearguns.

This epoxy is clarified which means it won't yellow in the sun or over time like other epoxies.

30 OUNCE KIT
ALMOST TWO POUNDS OF EPOXY

Enough to do at least 2 complete guns

Please call us at 650-868-4211 if you have any questions about this product or laminating your speargun.

EPOXY KIT

$62.00

Add to Cart

epoxy info:
2/1 ratio
7 hr hard time @ 78 degrees, 7 days full cure
working time 20 min at 78 degrees

general :
do not thin epoxy
always fully mix epoxy before adding any fillers or pigments.

mixing:
mix slowly and make sure to scrape the sides and bottom to limit bubbles and to get a complete mix.
only add pigments/ fillers after mixing

do NOT start assembling the gun for at least 4-6 days to give the resin time to cure (it will be very ez to scratch the first couple days